mike smith1
|
| posted on 18/4/06 at 11:54 AM |
|
|
Rear Lights
Comments on layout please and any advice, ref to setting out to meet final ride height of car etc and anything else you can think off, will try and
attach the picture if not, it will be in my archive!
Mike.JPG)
|
|
|
|
|
DarrenW
|
| posted on 18/4/06 at 12:08 PM |
|
|
I like them. Look perfect. i much prefer the round ones set at an angle. Id say youve got it about spot on.
|
|
|
mookaloid
|
| posted on 18/4/06 at 12:09 PM |
|
|
I like it. I see you have them a bit higher than I did - this is a good thing - I forgot about the minimum height thing and had to lift the rear end
on the springs and run high tyre pressures to get through the SVA
Cheers
Mark
 
Rescued attachment mk_P1010015.jpg
|
|
|
mookaloid
|
| posted on 18/4/06 at 12:10 PM |
|
|
You will need some stick on reflectors too - mine fell off shortly after SVA
|
|
|
shortie
|
| posted on 18/4/06 at 12:24 PM |
|
|
Look nice mate, only my personal opinion but I like the fog light in the centre but obviously completely up to you, after all it's your car!!
:-)
I assume the number plate light is going just above the number plate.
Also the reflectors will need adding.
Whatever you choose I reckon it looks good, nice job.
Rich.
|
|
|
eddymcclements
|
| posted on 18/4/06 at 02:01 PM |
|
|
I like it. My own preference would be for an offset fog, just as you have it. Symmetry is over-rated! Nice high-level brake light, too.
Eddy
|
|
|
ReMan
|
| posted on 18/4/06 at 02:10 PM |
|
|
Looks good to me 
|
|
|
mike smith1
|
| posted on 18/4/06 at 02:35 PM |
|
|
Thanks for all the replys so far, keep them coming, what is the rough ride height I should expect from the car so i can double check the hegights
etc.
Mike
|
|
|
zxrlocost
|
| posted on 18/4/06 at 02:46 PM |
|
|
I have 16" wheels 45 prof
my protechs are new
and are lowered so that there is about 3 lines of thread left on the shock bottom
my light sockets same as yours mike are 7cm from the bottom of arch to bottom lip of light housing
this makes around 350mm total gap which is correct for sva
although even on almost this setting which should be low theres a hands gap between wheel and arch so it best soften a bit cause it looks shite
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
.JPG)
