LocostBuilders - powered by XMB

Zetec Pics

whitestu - 8/5/08 at 01:57 PM

As promised some pics of my Zetec installation.

Bonnet Patch where CVH K&N went through. A scoop would be better.

Description

Inlet side.

Description

From above- you can just see the little Denso alternator.

Description

Exhaust side - modified Westfield CVH exhaust. Hope it's quiet enough!

Description

speedyxjs - 8/5/08 at 02:23 PM

Fits in there just nicly

Duncan_P - 8/5/08 at 03:05 PM

Looks good, wish mine was quite that finished

Out of interest did you make up the alternator bracket, or is it an of the shelf one?

[Edited on 8/5/08 by Duncan_P]

whitestu - 8/5/08 at 03:14 PM

quote:

Out of interest did you make up the alternator bracket, or is it an of the shelf one?

I made it - just a bit of angle iron with a piece of flat bar welded on the end.

It was a very tight fit beneath the carbs, so I doubt an off the shelf one would have fitted.

stevebubs - 8/5/08 at 05:24 PM

Your idler looks interesting below...any more pics?

quote:

Description

whitestu - 8/5/08 at 08:29 PM

quote:

Your idler looks interesting below...any more pics?

I'll take some more. It's a bit of a bodge - the pulley came with the engine, but it wasn't fitted so not sure exactly what it did.

It bolts onto the front of the head and lines up perfectly with the belt run.

I made a bracket to offer a bit of extra strength. Seems to work fine so far.

Stu

eccsmk - 8/5/08 at 09:15 PM

that looks really good top work

whitestu - 9/5/08 at 12:49 PM

Some pics of the idler pulley. They are the best I can get without taking off the nosecone.

Description

Description

Description