I am struggling to find what size of bolts/nuts I need :

- Bolts which connects the steering rack to the connecting shaft

- Bolts which attach the rear hubs (disc) to the rear hub carriers

- Master cylinder to the bulkhead (I also presume you need to drill holes)

- Also what size P-Clips do I need

Cheers

I'm pretty sure my rear disc set up is held onto the hub carrier with M10's

Not sure what M/Cylinder you are using but mine is held on with M8's

As for the rack i presume you mean the lower down link from the steering column, sure its M8 as well.

Remember to use high tensile 8.8 minimum strength.

hope this helps