got some boy-racer mesh today thought it was a bit expensive but now it's done i'm quite pleased with the results!
just sikaflexed into place!!
well chuffed another lo-cost solution!!
Rescued attachment bonnet vent.JPG

Rescued attachment side easter.JPG

Rescued attachment grill 1.JPG

Rescued attachment vent grille.JPG

Looks good,where did you get the mesh from and was it already black.

got it from a local motor factors. yeah it's already powder coated black!
about 17 quid.

You can also get it from Halfords.

Rich.

That black mesh looks great against the yellow bodywork!

Hi Kev, just a minor point, but havn't you put the bonnet grills in the wrong way round, surely they are there as extractors to get hot air out, as per the donor, IMHO Regards Chippy

not wanting to pick holes, but how is the bonet held down? looking at the second pic fromthe top and can't see any normal style rubber catches dzus fasteners. is the bonnet fully secured in that pic? only the shut line looks a bit wonky!

Nice grill btw

cheers,

Ned

The bonnet catches haven't been fitted yet.

thanks hellfire, no the catches haven't been fitted yet, as for the vents, maybe they should be the other way round but i prefer them that way so there