On a mk chassis what is used as a top hat to secure your clutch and throttle cables in the two metal tubes welded to the chassis. thanks

hi, on the throttle cable i used a bit of m16 studdin and m16 not, drilled down the center, and taped on end, which i seruced an adjuster in, adn passed my push bike brake cable through,but is because i have bike carbs,

and on the clucth i used a caori clucth cable which fit in ther prefect, nad put a sprin on teh other side to keep tension.

hope taht make sensce, if not i will try and dig out a photo, of the clutch.

stuart

edit, here is a pic of the throttle cable:
2

[Edited on 19/5/09 by Stuart_B]

Thanks for your reply Stuart, i was thinking of having some alloy turned down to fit in the tubes was after some feed back what others have done.