smart51
|
| posted on 22/2/08 at 11:33 AM |
|
|
welding round to flat
I want to weld a 40mm diameter 19mm thick bush to a flat plate. What’s the best way of filling the gaps? Fillets? Pieces of tube? Angle iron
instead of plate?
Suggestions please.
 
Rescued attachment temp.JPG
|
|
|
|
|
Mr Whippy
|
| posted on 22/2/08 at 11:37 AM |
|
|
Angle iron with out a doubt as the welds will buckle the flat bar, I do it like this
[Edited on 22/2/08 by Mr Whippy]
 
Rescued attachment untitled.JPG
Fame is when your old car is plastered all over the internet
|
|
|
smart51
|
| posted on 22/2/08 at 11:39 AM |
|
|
Like this?
 
Rescued attachment temp2.JPG
|
|
|
Mr Whippy
|
| posted on 22/2/08 at 11:46 AM |
|
|
no like this as the corners don't do anything, but you only cut them off once it's welded up.
 
Rescued attachment untitled1.JPG
Fame is when your old car is plastered all over the internet
|
|
|
