Thinking about it
|
| posted on 23/6/07 at 09:06 PM |
|
|
CVH Engine mounts
Does anyone who has fitted a 1600 CVH have any photos of engine mounts? (Or know anyone who has)
As it was from a front wheel drive car XR3 the original mount points are toward the front of the block as opposed to in the middle on most RWD
engines.
Just looking for someones ideas to steal! I hope.
|
|
|
|
|
iank
|
| posted on 23/6/07 at 09:33 PM |
|
|
Here is what Sylva did to fit CVH in the striker
http://www.sylva.co.uk/technical/cvh.htm
--
Never argue with an idiot. They drag you down to their level, then beat you with experience.
Anonymous
|
|
|
will121
|
| posted on 24/6/07 at 08:58 AM |
|
|
i managed to make some mounts bolted to the origional bolt holes and leave the altornator in its origional position, but its a tight sqeze between the
exhaust manifold and the back of the altornator. tried to take some pictures but not very clear!
 
Rescued attachment engine mounts 004.jpg
|
|
|
will121
|
| posted on 24/6/07 at 09:01 AM |
|
|
and yes i just noticed from the picture there is a bolt missing! picture of the altornator side
 
Rescued attachment engine mounts 009.jpg
|
|
|
