Gremlin
|
| posted on 14/4/03 at 08:17 PM |
|
|
Another stupid question!
Seems to be that time of year!
I have bent the rear top rail and pic bellow is of one of the bends.
Question is without thinking i have bent it towards the weld. It didnt split whilst bending which is when i would have expected it to but seems ok.
This isnt going to cause any problems later in the build is it? Do i need to do it again?
[Edited on 14/4/03 by Gremlin]
 
Rescued attachment Bend Pic.JPG
EZy GreMLiN
"The only way to get rid of temptation is too give in to it..!"
|
|
|
|
|
Stu16v
|
| posted on 14/4/03 at 09:46 PM |
|
|
Should be alright mate. It is only there to support the rear panel, not structural as such.
Cheers, Stu.
Dont just build it.....make it!
|
|
|
Viper
|
| posted on 15/4/03 at 06:43 PM |
|
|
If its not split now then as Stu said don't worry about it..
|
|
|
fastavatar.jpg){kind=avatar}
