meany
|
| posted on 1/5/06 at 08:08 PM |
|
|
diff brackets.
does anyone have any drawings of the diff brackets that hold a sierra diff in,
im buliding the Rorty irs backend and there does not appear to be any dimensions on the plans, i also have the GTS plans, but same again, they are
not on these.(presumably because you have to buy them from GTS).
|
|
|
|
|
big_wasa
|
| posted on 1/5/06 at 08:22 PM |
|
|
Gts plans say free updates. Just ask him.
|
|
|
mark chandler
|
| posted on 1/5/06 at 09:36 PM |
|
|
I jacked the diff into the position that I wanted it, then got some cardboard and cut a template.
Transfered this to a bit of 1/4" plate and cut out a pair (beefed up with a few bits of scrap since this was taken).
 
Rescued attachment NSR Chassis 18 Nov 2005.JPG
|
|
|
