Hi Now that I have sorted out the mess at the front end I need to do the same with the back.
When I purchased my "part complete" car I didnt realise what a state it was in.

The rear axle shock mounts rest part way on top of drag link brackets and are then supported by a piece of box section down to the axle tube. This box section gets in the way of the bolts holding the top drag link to the axle.

Has anybody got any pics of a "decent" finished setup.

Thanks

RD

have a look in davidm archive i think he has some if not i can take some tonight



Inside right

[Edited on 15/11/07 by nib1980]

axle finally finished
Here you go, the lower damper mount should have been made with 2 seperate plates to brace the bracket not a piece of box.

ATB Dan.

www.bitsablade.co.uk

Thanks Guys

Just the info I needed

RD