does anyone have any drawings of the diff brackets that hold a sierra diff in,
im buliding the Rorty irs backend and there does not appear to be any dimensions on the plans, i also have the GTS plans, but same again, they are not on these.(presumably because you have to buy them from GTS).

Gts plans say free updates. Just ask him.

I jacked the diff into the position that I wanted it, then got some cardboard and cut a template.

Transfered this to a bit of 1/4" plate and cut out a pair (beefed up with a few bits of scrap since this was taken).
Rescued attachment NSR Chassis 18 Nov 2005.JPG