Hi All

I need an aluminium 'tray' making. It's to sit below the seat of a bike I'm rebuilding (1970s Moto Guzzi) to take the electrics (Motogadget M-Unit, a couple of relays and possibly the ignition amplifiers).

I was tempted to have a go myself but I know it won't turn out the way I want it!

Rough sketch -


Description

The complicated bit looks like the slope at the rear (I haven't measured the angle yet but it's close to 45).

Ideally, the joints at the corners would be welded / sealed to keep the tray dry (ish). The top will be covered by the seat.

Here's the bike place it needs to go - anybody interested in making this for me?


Description

Ta

Wyn

try Terry O'Hara in TyCroes Wyn. He has a folder and specializes in alloy welding.

Does cash jobs too!

239 Pontardulais Rd, Tycroes, Ammanford SA18 3RD
01269 592188

Cheers Rich

I've heard his name mentioned before - will give him a try! I'd ask Endaf but I know he's flat out busy!

Are you going to the club meeting tonight? I'll bring your wishbone!

Ta

Wyn

[Edited on 3/11/15 by lsdweb]

Terry himself has semi retired so you'll probably deal with Clive - tell him Richard Gower View Foods sent you as he does a lot of stuff for me at work

Yes - see you there