Has anyone made a mod to the front of the chassis to prevent the joint between the l's and the j's from protruding through the skin? I think that I recall someone proposing a front suspension bay in which the j's ended at the infamous fu's and the top tubes from there forward were parallel to the centre-line, but couldn't find it in the archives.

Regards,
Fussy Pete

Isn't that how they do it? You could make the section up then cut the pointy bits off and weld a flat strip round the gap you've just made.

GTS plans

Bit like this?
Rescued attachment Virtual Ally3.jpg

Wow, three good solutions in a few hours. Thanks Paddy, Mr. G and Mark! Only 24,999 details to go...

May your builds prosper,
Pete Byar