Got engine started M52TU25 on modified MS42 ECU and absolutely ocer the moon. The engine idled ok but after giving it a rev it died, it threw up some
fault codes (some expected as the faults relate to components no longer exist).
https://youtu.be/sMSArNFT5rA
Fault codes present after first run;
209 EWS -Message Error
11 Tank Pressure Sensor (EVAP System)
130 CAN Signal ASC -Timeout
35 Aux. Air Injection System Relay
131 CAN Signal Instrument Cluster -Timeout
132 CAN Signal Instrument Cluster -Timeout
125 Activation Electric Fan
0 - unknown
Hopefully none of these will effect the running of the engine as limp mode and EWS immobiliser has been deleted. Not sure why getting code 125 as
engine cold?
Those error codes can all be ignored I think, although obv you may have difficulty with passing emissions without the air injection system. Try unplugging the MAF and seeing if that sorts out the stalling issue - if it does, you probably need to replace it.
quote:
Originally posted by rodgling
Those error codes can all be ignored I think, although obv you may have difficulty with passing emissions without the air injection system. Try unplugging the MAF and seeing if that sorts out the stalling issue - if it does, you probably need to replace it.
Ah right, didn't know that. In that case probably not an issue - IVA were quite happy to warm up the engine and basically help me get a pass on that point.
Craig, did you resolve your stalling issue. Mine does exactly the same!
Chris
quote:
Originally posted by CTLeeds
Craig, did you resolve your stalling issue. Mine does exactly the same!
Chris