Was a bit bored today after I'd been for a hoon, and after discovering that my Sucker mount Hague cam mount form my old tin top was next to useless, I decided to make a bracket that would replace the sucker.

Numerous rubbish attempts over the past few weeks (all too flexible) had me pondering buying a whole new clamp.

At this point I stumbled across the CF sill covers that had come with my Aeroscreen on offer (think they were £17 or something) but were too wide for my Indy. I was going to flog them on here and then had a thought - use them both to make a box section, nice and rigid, and mount the bracket on that?

Conveniently just longer than the distance between the harness mounts, it looked like it could work...


Cam mount1


cam mount above


It did!

Haven't managed to try it yet as the camcorder gave up the ghost today, typical...

very nice

Ta. Very much a beginner in all this so starting small and simple